Angled Cut

Create a seam that runs a a non-right angle.

Angled_Cut_Button.png

Cuts may be created at any angle using this tool. When an angled cut is created in a room with unlocked seams, that room's seams automatically become locked.

See:
Lock Seams


How To:

1.  Select a cut on which the angled seam will be placed.

Angled_Cut_step_1.png

2.  Click the "Angled Cut" button under the Ribbon Bar's "Estimate" tab and move the cursor over the drawing area. A red dot will appear on one side of the cut.

3.  Use the red dot and its accompanying measurements as a guide to find the starting point for the new seam. Left-click to place the start point.

Angled_Cut_step_2.png

4.  Another red dot will appear along with a set of guide measurements and a red line linking the start point to the dot's current position. Locate the end point for the cut and left-click.

Angled_Cut_step_4.png

 

 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.

Powered by Zendesk